After making a mess of my first attempt at the Hull Pixel Bot I started again, re-printing the skids, motor supports, sensor holder and LED support arches in very short time. The Nfire1 is not particularity fast and the large base and top take 5-6 hours to print, which for me means setting them going on a weekend when I can be around to check on the print progress.
Two and a bit hours into the print I came back to this wacky looking mess. As far as I can tell one of the belts has again slipped throwing off the print plane and resulting in the odd formation below. I gave everything a cursory inspection and tried again with similar results, so I need to re-tighten the printer belts and try again.
Comments
Post a Comment